Welded the wrong piece to the base plate
Welded the rest of the pieces backwards without knowing
Fixed first wrong piece by cutting at an angle
Test fit piece and realized all pieces were welded backwards
Modified saw from vertical bandsaw mode to horizontal bandsaw mode. Electrical cable was trapped under the wheel and tore the wiring out of the motor control box
Motor still worked so cut base plate off of one of the pieces. Coolant pump didn’t pump fluid
On the second piece, dropped the saw blade on the piece too quickly and without cutting fluid burned up the saw blade.
Opened control box on bandsaw and fixed ground wire that had pulled free. Fumbled tool and dropped it in the slack tank.
Closed up shop and went inside before I broke, burnt, or otherwise ruined anything else.
