Well, I did it! I bought a #5 Fly Press for blacksmithing, and it needed a table. This table not only needed to withstand the weight of the press (a little less than 500 pounds), but it also needed to endure the torsional stresses caused by using the fly press.
Here is was I came up with.
Check out my YouTube channel and watch the build.
This is a no-paint refurbishment of a Littlestown Bench Vise No. 25. I had every intention to paint this vise in the […]
This project was a gift for my nephew. You can read about the process in the following posts. Learning to Blacksmith #5 […]
This is my first blacksmithing project and I forged two heavy duty curtain rod brackets. Meet Tank and learn about the process
This was a fun project involving a bit of woodworking and a fair amount of blacksmithing. I forged two 6″ brackets, both […]
